|
|
 |
|
We’re moving along ... slowly , but surely
As you can see everything is coming along well for what we have to work with. Soon Becky well be able to prep the work
done and seal up the welds and joints both up top and under all reworked areas.
|
|
|
Now that we almost have the right side almost done "roughed out" I can go and do the same on the other side, which appears
to even in worst shape . O well ,measure twice and cut and weld once .
This picture is a bit on the darkside "along with everything else on this project",the cowl supports and everything associated
had to be replaced as they were too far gone. I just kept cutting back until we had good solid sheet metal to work up to.It
would of been easer to do all the underside welding with a lift , but the only lift I could get is a ride to the store.
|
|
|
|
|
|
|
|
|
|
|
|
NEXT PAGE CLICK HERE
DISCLAIMER :
Street Rodding is an enjoyable but serious hobby and like any other hobby safety
is foremost the number one concern. Therefore, since I am not by any means a professional car builder just
a hobbyist, any information contained within these pages are just my opinions design/s and ideas that
worked for me.
Furthermore, I make no claim/s as to the accuracy of the information and/or procedures used herein
, nor will I accept responsibly and/or any liability/s for the use or abuse should any of the said information used by any
party/s should cause injury. Always consult your local and state safety laws and regulations !
Any person/s whom may nominate to use, build and/or copy the method/s in this site would be doing so at his or her/s own risk .
|
|
|
|